Wavy Metal Roof

A corrugated panel has a repeating wavy or rippled pattern across its design.

Wavy metal roof.

A layer of felt paper acts as a base and goes down before the shingles for every installation. Corrugated panels are connected by overlapping the sheets and then securing them in place with exposed fasteners. Let s go into some more detail to give you a better idea. Having wet or poorly placed felt paper under your shingles can cause your roof to be wavy.

In technical terms oil canning is referred to as elastic buckling more commonly known as stress wrinkling. The shingles may look wavy right. Steel aluminum zinc or copper. Some of these can include a warped foundation damaged underlayment distortion from heat or even bad workmanship of the roofers.

Is your roof new. Causes of a wavy roof. If you have recently had a roof installed and it has started to look wavy there are the possibilities. Wavy roofs are not normal and they do not happen on their own naturally.

The carpenter may have failed to put all of the crowns up on site framed roofs. However that pronounced wave will nearly always signify one big thing. It can occur in any type of metal panel. If the material was.

There are several reasons for a wavy looking roof. The felt paper used on the decking was potentially wet or bubbly when laid down. These panels can be used for roofing siding decking and flooring. A roof with a wavy look to it can be caused by a number of reasons but the problem may be short lived.

When some of the crowns are up and some are down then the roof has a wavy look but it is still structurally sound. If your new roof was laid over an old layer of roofing this could cause. Wavy or warped roofs don t happen naturally. Poor framing practice is one of the more common reasons for roof waviness.

It was the first mass produced metal panel design in the united states. This type of roof wave is usually only seen after a new installation. There are a few reasons why it occurs but please remember that it is dangerous for you to attempt to diy or self inspect your roof. Visible waviness in the flat areas of metal roofing and metal wall panels.

Let s take a look at some of the typical causes of a wavy shingles especially after a new roof is installed. Rather rely on a local roofing contractor for professional help. If you have more question or concerns about your wavy or warped roof and would like a professional consultation contact us at schroer and sons. So what are some of the reasons your roof can look wavy.

Thankfully this is usually corrected with a little time and heat.