Toyota Sienna Rear Vent Window Removal

Remove side window assembly rear lh.

Toyota sienna rear vent window removal.

Toyota sienna service manual. I took the van in for 90k service and asked the dealership guys to see what it costs to fix it. For now i have a piece of rope tying it all together to keep the window. Closing the windows and moon roof quarter windows.

Bolt 5 5 n m 56 kgf cm 49 in lbf remove the window. B remove the clip 2 bolts and power vent window motor. C remove the 2 nuts and rear side window. Be sure to pull of the entire cushion assembly don t pry the cushion off from the assembly.

The quarter windows can be opened to bring in fresh outside air for additional. How to replace the rear vent window in a 2007 sienna. 2004 sienna rear vent window loose the rear vent window became loose on my 2004 sienna. Toyota sienna 2010 2020.

07117 58090 07117 78050 07117 88060 07117 88070 07117 88080 hint. Remove the 2 nuts and 2 bolts. They said it was over 400. Somehow my power rear window vent driver s side broke.

It was yellow so it showed up pretty good but cleaned up good. It was a little runny and some oozed out when putting the window in the track. There are four screws to remove one by the dash behind a cover odd 95 of the time that screw is covered by the dash when the door is closed one at the door handle and two under the arm rest cushion you have to pull off. Glass is slightly loose at front hinge end and therefore doesn t answered by a verified toyota mechanic.

I have no idea how but it snapped. I tried to talk them into a warrantee replacement the. Toyota sienna 1997 2003 a disconnect the power vent window motor connector. It was working intermittently but even then it sounded quite weak compared to the right one.

One the hatch panel is off you will see that you can now remove the side trims. Remove back door scuff. I let it dry and then scraped off the excess with a razor blade. I have a 98 sienna le and the left rear vent window seems to have thrown in the towel.

Remove the 10 mm bolt that holds the pull handle if you have a pull handle and then using a flat tool like a stiff putty knife insert the tool between the vinyl trim and the tailgate to loosen the plastic clips there is like 18 of them. I used a weatherstrip adhesive from permatex.